How to attach a file in the discussion forum?

Topics: 4.2a

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   2 Replies   Last post: October 8, 2012 4:14am UTC
Muthuraman Chinnadurai

Muthuraman Chinnadurai

October 7, 2012 3:53pm UTC

How to attach a file in the discussion forum?

Hello,
Am new to comsol and would like to share my doubts in this support forum.
When i tried to attach a model on the add file option,it says that the file is not supported.
So Please help me how to attach a file in this Discussion forum.

Thanks in advance Sir!!!

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Ivar Kjelberg

Ivar Kjelberg

October 7, 2012 6:28pm UTC in response to Muthuraman Chinnadurai

Re: How to attach a file in the discussion forum?

Hi

the FORUM does not accept all types of files, png and jpg as well as valid COMSOL mph works OK
But model files you should clear the solution and the mesh to make them far smaller, els the COMSOL servers might well explode ;)

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Muthuraman Chinnadurai

Muthuraman Chinnadurai

October 8, 2012 4:14am UTC in response to Ivar Kjelberg

Re: How to attach a file in the discussion forum?

Thank you sir!!!!

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines